Valentines Day Clip Art Card

Just 1 Valentines Day clip art kit has been used to make this easy 3D card.

Simply print off the paper and graphics required, and mount along with basic cardstock adding a few embellishments for finishing touches.

Scroll down for instructions and materials.

Printable Craft Supplies Used

Valentines Day Clip Art
(c) Whimsy Primsy Graphics

This card is created on a white cardstock base, cut into a 6 inch square.
Stick down the red heart paper from the clip art kit, slightly smaller than the base, leaving a narrow white border around the edge.
Mount the "Love" border onto some red cardstock and add it to the front of the card towards the bottom.
Cut out the large checked heart and add it to the front with 3D foam pads to raise it up.
Cut around the "Cupid" and add him to the front of the card, with either 3D foam pads or Pinflair Glue Gel, so that he sits to the bottom right of the heart.
Add some fine glitter to the wings with a Quickie Glue Pen.
Wrap some red organza ribbon around the spine and tie in a bow.
In each circle around the heart shape I have added a small blob of Liquid pearls. Leave this as the last addition to the card as it takes spome time for the pearls to dry.